Call Us: +86-023-68889458Email: luck@moyadapower.com
enLanguage

Slip Treatment Of The Clutch

Dec 08, 2022

When clutch slippage occurs, a correct analysis of the cause of failure should be carried out.

1. The cause of clutch slippage

(1) The driven disc friction blade is over-worn or the rivet is exposed;

(2) The clutch pressure plate spring is too soft or broken;

(3) The free stroke of the clutch pedal is too small;

(4) The driven disc friction plate has oil stain or aging and hardening;

(5) The clutch and flywheel joint bolts are loose;

(6) The return hole of the clutch master pump is blocked.

2. Troubleshooting sequence and orientation

(1) Check the free stroke of the pedal, if it does not meet the standard value, it should be adjusted;

(2) If the free stroke is normal, remove the clutch bottom cover, check whether the clutch cover and flywheel joint bolts are loose, and if there is loose, it should be tightened;

(3) Check whether there is oil on the edge of the clutch friction plate, if there is oil, remove it, clean it with gasoline or alkaline water and dry it, and then find out the source of the oil and remove it;

(4) If it is found that the friction plate is seriously worn, the rivet is exposed, aged and hardened, burned and soaked by oil, etc., the new piece should be replaced, the new friction piece replaced shall not have cracks or damage, and the depth of the rivet should comply with the regulations;

(5) Check the oil return hole of the clutch master pump, if the oil return hole is blocked, it should be dredged;

(6) If the fault cannot be eliminated after the above inspection, adjustment and repair, the clutch is disassembled and the spring force of the pressure plate spring is checked. When the pressure plate spring is good, the length should be consistent, if it is uneven, it should be replaced with a new product, such as a slight reduction in elasticity, the length difference is not much, and the gasket can be added or subtracted under the spring to adjust.