Call Us: +86-023-68889458Email: luck@moyadapower.com
enLanguage

Precautions For Clutches

Dec 05, 2022

1. The clutch must be cleaned before installation to remove anti-rust grease and impurities.

2. The clutch can be installed coaxially, can also be installed in a split shaft, the axial direction must be fixed, the active part and the driven part are not allowed to have axial channeling, when the axis is installed, the coaxiality between the shaft of the active part and the driven part should not be greater than 0.lmm.

3. When the wet electromagnetic clutch is working, lubricating oil must be added between the friction plates, and the lubrication method adopts (1) sub-oil lubrication; (2) Oil bath lubrication, the part immersed in the oil is about 5 times the volume of the clutch; (3) Shaft oil supply lubrication, in high-speed and high-frequency action should adopt the shaft oil supply method.

4. When the tooth-embedded electromagnetic clutch is installed, it must be ensured that there is a certain gap between the end face teeth, so that there is no grinding phenomenon during idling, but it should not be greater than the δ value.

5. The electromagnetic clutch and brake are Class B insulated, and the normal temperature rise is 40 °C. The operating temperature during the limit thermal equilibrium is not allowed to overspeed by 100 °C, otherwise the coil and friction parts are prone to failure.

6. Power supply and control circuit, clutch power supply is DC 24 volts (except for special orders). It is obtained by three-phase or single-phase AC voltage by step-down and full-wave rectification (or bridge rectification), and the power of unregulated and flat wave requirements is large enough. Half-wave rectified power supplies are not allowed.

7. Requirements for clutches in automobile drive trains

Depending on the use of the clutch, it should meet the following main requirements:

The joint is smooth and gentle to ensure a smooth start of the car,

Fast and thorough separation for easy gear shifting and engine starting;

It has a suitable reserve capacity, which can not only ensure the transmission of maximum torque of the engine but also prevent overload of the drive train;

The transmission inertia of the driven part should be as small as possible to reduce the impact when shifting gears;

With good heat dissipation ability, when the car needs to operate the clutch frequently during driving, it will make the main and driven parts of the clutch slip relative to each other, resulting in frictional heat, if the heat is not dissipated in time, it will seriously affect its working reliability and service life;

The handling is light to reduce driver fatigue.